Need Appliance Repair Service? Have a general question?
We love solving problems! Let us know how we can help by reaching out below.
Local Reviews
for Good Hope, GA
Powered by Fluid LOCAL
Marvin P.
REFRIGERATOR WHIRLPOOL WRS555SIHZ03 "cut out broken water line installed fitting tested unit ok now not sign due to COVID-19 protocol. Q1: No, Q2: No"
Marvin P.
REFRIGERATOR WHIRLPOOL WRS555SIHZ03 found water line cut leaked when connected order part; ordrng 3 2300868 (fitting)s and 3 2198677 (connector)s and 3 4373559 (fitting)s
Marvin P.
RANGE WHIRLPOOL WEC310S0FW3 "new burners cust said it will not get hot enough to cook her food checked unit working ok advised cust back to dealer for upgrade not sign due to COVID-19 protocol. Q1: No, Q2: No"
Roy T.
WASHER MAYTAG MVWB765FW3 AUTH#WNBJXNBAL2 FOR DOUBLE LABOR CHECKED ONE OTR AND FOUND EXHAUST FAN AND RANGE LIGHT NOT WORKING REMOVE UNOT FROM WALL AND REPLACE ONE MOTOR-FAN CAP AND ELECT CONTROL REST ALL WORKING OK
Roy T.
WASHER MAYTAG MVWB765FW3 AUTH#WNBJXNBAL2 FOR DOUBLE LABOR CHECKED ONE OTR AND FOUND EXHAUST FAN AND RANGE LIGHT NOT WORKING REMOVE UNOT FROM WALL AND REPLACE ONE MOTOR-FAN CAP AND ELECT CONTROL REST ALL WORKING OK
Roy T.
WASHER MAYTAG MVWB765FW3 "F7-E9, LOCK ROTOR, F0-E3 OVERLOAD, F7-E0 LOSS OF PWR. CLUTCH RUBBING ON SLIDER, UNIT NOT GOING INTO WASH CYCLE.ORDER PARTS; ordrng 1 W11134159 (GEARCASE) and 1 W10734521 (SLIDER) and 1 W10754448 (CLUTCH)"
Roy T.
WASHER-TOP LOAD MAYTAG MVWC565FW1 CHECKED ONE WASHER TOP LOAD AND FOUND THE FILL VALVE BLOCK REPLACE ONE VALVE ASSY TEST WASHER WITH CUSTOMER
Roy T.
OVEN WHIRLPOOL WOS51EC0HS01 found loose conection to blower fan reconected connectors and unit is now operating as designed showed customer unit is now operating as designed
Roy T.
WASHER MAYTAG MVWC565FW1 check one washer and found error code f8-e1 long fill remove dill hose and clean test washer working well
Roy T.
WASHER MAYTAG MVWC565FW1 check one washer top load and found error code f8-e1 long fill and found outlet loosing netural and drain pipe too low test washer in another outlet and show customer washer not cutting in and out raise drain hose and advice customer to raise drain pipe no lower than 39"and higher than 96" test and show customer washer working
Horace B.
RANGE - ELEC WHIRLPOOL WFE775H0HZ1 REPLACED DEFECTIVE CONVECTION FAN MOTOR/TESTED/ISSUE CORRECTED
Horace B.
RANGE - ELEC WHIRLPOOL WFE775H0HZ1 OVENS CONVECTION FAN NOT FUNCTIONING/TESTED VOLTAGE FROM MAIN CONTROL FOUND 123V PRESENT & 94/OHMS RESISTANCE FROM CONV FAN MOTOR/NEW MOTOR ORDERED; ordrng 1 W10860189 and 1 W11106265